![]() (POU data protection version 2.0 or higher) Version control is available for projects on which POU data protection is enabled.Added functions to import and export the option settings.Added a function to manage projects by file.EtherNet/IP Connection Setting supports the following new target device:.Ver.1.55 : July 2023 Sysmac Studio Version 1 Auto-update Support of New Type Solved the problem that E_COM_001 might occur in Soft-NA depending on the IP address of a communication destination during secure communications with a controller.Solved the problem that E_PAG_011 might occur when screens were switched with a button release event while a pop-up page was being displayed.Solved the problem that objects under IAG might be displayed with a different font size from the setting when TabControl and IAG have objects with the same name.Solved the problem that short lines did not edge when two or more lines of text were left-aligned or right-aligned on a lamp object.Solved the problem that copying and pasting device data other than HMI while a page was opened might cause an error.Solved the problem that changing a controller name immediately after opening a project was not reflected in the HMI.Solved the problem that Sysmac Studio might terminate abnormally when performing a replacement of recipes.Solved the problem in the Simulator that a major fault occurred due to "Illegal User Program/Controller Configurations and Setup" when the retained variable memory usage in NX502 exceeded 2MB (50%).This response solved the problem that an initial value of the absolute encoder did not become 0. Solved the problem that an encoder axis’s actual position calculated with SIM_SetVelocity instruction did not become 0 or less in the Simulator.Solved the problem that the Simulator would not start when a pulse output unit and digital input unit on the NX Bus were assigned to a servo axis in the Simulator. ![]()
0 Comments
Leave a Reply. |